Comments on: Quick review: PA Security Cable

By: Brian

Brian — Mon, 13 Dec 2010 13:06:29 +0000

I love having my PA and being locked in my CB6000S

By: Wired « Denying Thumper

Wired « Denying Thumper — Sun, 05 Apr 2009 15:20:34 +0000

[...] denial, PA cable, penis, piercing A while back, I got a PA security cable from Kept For Her. As I said at the time, I couldn’t wear it due to the stress it put on my piercing by keeping the cock fully [...]

By: Tom Allen

Tom Allen — Thu, 12 Feb 2009 03:10:03 +0000

Speaking of which, I often wonder about guys sneaking a curious glance at the guy next to him. I’ve learned to be very discreet, but holding a square of tissue or paper towel under it to catch drips is a must for me, and I’m wondering if one day somebody will ask about it.

By: thumper

thumper — Thu, 12 Feb 2009 02:48:16 +0000

Good, because if you were standing next to me, you might get a little wet.

By: Tom Allen

Tom Allen — Thu, 12 Feb 2009 02:47:04 +0000

Too much like high maintenance for me, bro. I *like* the idea – I just like it from a few feet away.

By: thumper

thumper — Thu, 12 Feb 2009 02:11:16 +0000

OK, so I checked the instructions and I was doing it right.

At this point, I honestly don’t understand how it’ll ever not bother me, though a larger gauge might help.

Peeing with the PA takes extra attention, but is totally possible (as long as getting your hands a little wet doesn’t freak you out). Peeing with a PA in a plastic tube depends heavily on gravity…if ya know what I mean.

By: Tom Allen

Tom Allen — Thu, 12 Feb 2009 01:56:49 +0000

I think that the assumption is that the ring would be large enough in diameter to extend past the slot, so that the cable really is still on the outside. I always wondered about that – shrinkage from the cold is a big factor up in New England – and no less so in your neighborhood.

So, that said – how about one loop attached to the PA and the other end hanging through the cage and looped up to the lock?

I still don’t know how y’all pee with a PA, let alone a PA in a plastic tube. I think that I’m sticking with my new KSD-G3.

By: thumper

thumper — Wed, 11 Feb 2009 19:42:48 +0000

In my defense, Tickleberry shows a similar cable worn outside the tube. I knew I got the idea from somewhere.

By: thumper

thumper — Wed, 11 Feb 2009 19:38:18 +0000

Wait a sec. Is it possible I’m doing it wrong? I put the cable on the outside of the tube (as my pictures show). I wonder if I should put the cable on the *inside* and instead of fixing it to the lock tried putting the loops around the locking pin? The cable’s not too flexible since it’s somewhat thick and covered in nylon, so I’m not sure it’d make much difference. I wonder if my presupposition about how it worked overrode my eyes when I read the instructions. I’m getting out tonight, so I’m not sure I’ll have time to try out my idea. Now that I think about it, it seems to make more sense than the way I did it…

The elastic idea is one I’ve noodled with after hearing about your experimentation with it, but something that I could conceivably defeat without tools doesn’t trip my trigger as much as the steel cable does (plus, *come on* wiring your meat to a steel cable is way sexier than a rubber band). Your experimentation with elastic was inside the tube, correct? I seem to remember you saying you were going to write that up (but I’ll forgive you for not since you’ve been in pain and all ).

By: Tom Allen

Tom Allen — Wed, 11 Feb 2009 17:13:56 +0000

What if you put the loop at the end of the cable onto the PA ring itself, and then closed it with the ball? Then only a single strand need to hang through the cage, and you could have more slack.

Also, why not consider looping an elastic through, instead of the cable? Again, more “give” might be more comfy and less irritating.