Back in November sometime, I decided to start experimenting with different email clients both on my computer and my phone. In doing so, I set up my work addresses (there are two of them), my personal address, and the one or two other old addresses that still occasionally receive something of value. I forgot to set up my Thumper mail. Therefore, I didn’t see any emails to that address until just the other day when I thought to myself, “Huh. I haven’t seen any feedback from the…uh…um. Oh. Right.”
So, if you sent me any email since about the last week in November, sorry! It seems I’m an idiot. Without further delay, here’s the stuff I can answer that was sent to me while I was on my little email vacation…
An anonymous reader asked:
I’m pretty interested in buyin a Looker02.
I’m not sure how to measure, not getting it all what Dietmar says (he’s currently in holiday, too)
How to I measure? The penis while *totally* (after cumming or so) flaccid? The circumference while flaccid or while hard?
Yes, measure while totally flaccid. Not the tiniest your dick gets, but in its normally soft and sleepy state.
Please note my penis grows a lot when becoming erect 😉
Lucky you. It’s my experience that the device should be as close to your flaccid size as possible, but the penis on me only gets about double its flaccid size, so YMMV.
I want to extend the plug beyond the A-ring from 1cm to 2 or 2.5cm, to make security a little bit higher. Is this anatomically possible?
I wouldn’t recommend it. The little bit that sticks out does make the device marginally harder to get out of, but it’s still not very secure (but no less secure than any other non-PA involved device). You’d have to make the insert go way up inside you to use it as an actual security measure. However, that little bit is the part that can irritate your urethra while being strenuous (ie, jogging). I’d stick with the 1cm and pretend like it’s secured with magical powers.
The hardest about is about measuring the mm for the cockring. What’s the best method? (I have a girlfriend who can do this but we’re always getting something else )
This is the..uh…hardest part. It’s also why I recommend a CB-6ooo or similar plastic device before going to metal, but whatever. You need to measure around your cock and balls using a measuring tape or string (measuring the length of the string afterward). Cinch the tape/string until it’s just snug, but not tight. That’s about where you need to be. Note that the likelihood you’ll end up with a size too small or too large is high, so you might want to get two A-rings. Also note that, over time, you’ll likely want to move to a smaller ring with wear.
I fear you may have not waited and just went ahead and made your purchase. If so…did you see my apology up there?
I am going to order up a Looker 02 in the new year as Steelworxx is shut down for holidays until the new year.
Sounds like Dietmar’s going to be busy when he gets back from vacation.
I’ve read all of ur reviews and was wondering if u still think the urethral tube couldn’t possibly be any longer now that u have spent a lot of time in the device? Reason I ask is I had spent a lot of time in the past sounding and I slid a sound in marked with tape to where the urethral tube will sit in me while I was wearing my Jail Bird. I can comfortably go a lot deeper than the the 1cm past the cock ring that they allow for when they make the Looker 02. I am going to have him make it so its approx the same size as my Jail Bird and as I was wearing it when I slid the sound in I thought it gave me a pretty good idea. Having said that tho I have never had a sound in all day or slept with one in obviously so I thought I would get it made to pass the cock ring 2cm. Feels like it could easily go an inch past but 2cm sounds safer. Thoughts?
Like I said above, the issue isn’t how far you can get a sound up there (the insert doesn’t really go very far), it’s that the device it’s welded onto will be moving around quite a bit and sending the end of the insert into all kinds of directions inside your body. It’s possible an extra centimeter won’t make that much difference, but personally, I wouldn’t want it any longer.
Number 2 concern, as I had spent a lot of time sounding before chastity I used to be stretched out to accept a 14 mm sound. I think I require a larger ball on the end of the urethral tube. Since I don’t jerk off anymore I don’t sound anymore. I’m sure that 14mm is not currently possible but I know I am still stretched out. U don’t know my body so I know u can only give so much info. I was wondering if u wished the ball at the end of the urethral tube was larger to hopefully not allow urine to get past it?
Urine getting past the ball doesn’t bother me. I actually think it’s beneficial as it does the normal job of urine and keeps the urethra cleaned out. That doesn’t mean I don’t wish the tube’s inner diameter wasn’t larger, though. The relatively narrow insert tends to retain urine and that leads to dripping and leaking (which is the device’s biggest drawback, IMO). Were I to do it over again, I’d get a fatter insert that drained easier.
Concern number 3 and last one of this long winded email. Ha. When I ordered my Jail Bird I know the cock ring was sized perfect. I think it still fits perfect but I know my body has a permanent impression of the ring marked around my cock and balls now. I was thinking about getting it made an eighth of an inch smaller. Have u noticed that u could possibly have gotten a smaller cock ring than when u first became chaste? I don’t want it to be too small and I was lucky to get a perfect fit with my Jail Bird so I would like this experience to be the same.
If you think it’s perfect, don’t mess with it. I really get wanting a smaller ring, but don’t fuck it up.
I just found your site the other day and I have been reading your post starting back in 2008. I have read the first two years. First congratulations on you and Belle for continuing to live your relationship for over 5 years now. I had to skip ahead on your blog to the present to answering a question I had. Why no strap on play for you or at least have her in force butt plug wear at times on you. You seem like you are attracted to the male penis, why not take that attraction to her fake penis? Or maybe she is not into that. Am I answering my own question?
Belle has said in the (far distant) past that she’s not interested in using a strap-on on me and I haven’t had the guts to ask again. I would really be into trying, though.
I bought a CB6000 and still have it, my wife and I used to have kinky sex but our 3 year old, got in the way of that. Perhaps in the future.
Yeah. Damned kids. Said with much love and affection, of course.
Maybe you have tips but I couldn’t get into the CB6000. Now I am not huge, about the same size as you maybe a little bigger at 6.5 inches erect and a lot less when not. But the width, I am a little bit bigger then the width of the chastity device. I bought the CB6000 curve. Should I just put a lot of baby oil on and force it on or should I look for something bigger(any suggestions) and also do you shave your area. I read that someone should but my wife doesn’t like that area shaved. Well any advice would be appreciated and Happy Holidays, hopefully you are able to cum this month. Denial might be the best present.
Six and a half is almost a full inch bigger than me. Based on what you wrote, it sounds like you’re wider than the CB6K while flaccid. If not, no problem. It’s supposed to be smaller than your hard-on. If so, yeah, that could easily lead to edema which is not serious if the device is removed promptly, but is uncomfortable. I have no experience at all with the Curve, unfortunately. You could experiment with the CB6K and put it on and just keep an eye on your dick. If there are no issues with edema, then damn the torpedos. Your best bet may be a bespoke steel device.
I kinda shave. I like to keep the hair off the shaft, scrotum, and perineum but Belle won’t let me shave it everywhere else. I do keep the surviving pubes trimmed to something between 1″ and 1/2″ long. Shaving can also lead to irritation as the stubble grows out and the device puts it in contact with the surface of skin that usually doesn’t have to deal with that kind of thing.
No, I was not able to come this month. But the month’s not over. But that doesn’t make any difference.
Last week I traveled from LAX to Monterey CA on a scheduled airline. Because I was traveling alone and my wife would not be embarrassed if anything overt happened, I persuaded her to let me travel with my Lori steel tube on.
It was late on a weekday night, no travelers before me at the mag-and-bag checkpoint, and I was invited to approach via the over-75 age line, despite not being quite qualified by age. Leave shoes on, take off belt and cell phone. I let them know I’d not be able to pass the mag test, and I didn’t. The assumption was that I had shrapnel in me, to which I replied that it wasn’t that deep into me.
The inspection that followed is why I write. I had a thorough pat-down except for the gonads, and then a test for explosives (that treated paper they wipe over your clothes), and when I passed those, I was free to go. There was no further discussion of what metal I had, and it was no more intrusive than if I’d refused to accept the newer type of scanner.
At least in this single case, it’s encouraging that air travel while locked in steel is no big deal.
That’s very interesting. I’ve wondered if the pat-down was sufficiently invasive to detect a steel tube. I assume you didn’t go through the millimeter wave scanner and only used the metal detector. I wonder how they’d have reacted if they had seen it thought your pants.
In any event, thanks for the info!